Farmall & IHC Tractors Discussion Board |
Re: What to do .....13' disc---560d..??
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Armand Tatro on May 16, 2007 at 18:12:14 from (67.176.252.97):
In Reply to: What to do .....13' disc---560d..?? posted by Clefus on May 16, 2007 at 17:39:54:
If I rember right we had a #37 wheel lift tandom disc 14' wide in heavy black fall plowing. The 560D would pull it in high 3rd. and lift & throw dirt, gangs set shallow to medium and cutting 3to4" deep. We also borrowed a 15' case disc set the same way with no problems. The 15' case was normaly pulled by a 830 case.(this was spring work.) In the fall we would angle the gangs to the the max and disc corn stalks with wheels up with the 560D in high 3rd. with no problems. The 560 was putting out 60 to 65 hp. Under the same conditions the M or the 400 would only pull in 2nd. or high 2nd and felt like you were pulling a 3/14" plow running 8' deep.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|