Farmall & IHC Tractors Discussion Board |
IT shop manuals
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Butch WI on May 11, 2007 at 07:16:34 from (69.179.89.120):
I have a 460 utility and I'm wondering if the I&T shop manuals (IH-25) for the 460, 560, 606, 660, 2606, will have the 460 Utility info in it? I have heard that there is a separate owner/operators manual for the utilities. I see that the 00 and 50 series are all included in the IH-10 I&T (rowcrops and Utilities alike). I just drained the hyd oil (7.5 gals) slightly discolored and replaced with a new filter and 10 gallons of Hy-Tran Super? or supreme (don't recall the last word) and a new filter. the 2pt still wont lift on its own unless its at half throttle or more. It is Very touchy to get in the right position. I wish to use it to spread manure but am concerned about accidentally bumping the lift lever and causing damage to PTO shaft are these normally that reactive to slight movements of the control lever?? Butch
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|