Farmall & IHC Tractors Discussion Board |
Re: FAST HITCH problems...help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Clefus on May 10, 2007 at 03:19:15 from (75.88.177.58):
In Reply to: Re: FAST HITCH problems...help posted by georgeky on May 09, 2007 at 19:20:07:
THANKS Does the large bolt that the plow spins on need any certain torque?? I originally was going to remove it but didnt.... stuff was a little rusty and hard to move to reset it...i tried backing up as you said but it wouldnt go due to rust... Where does one get info ( or manual) on setting up this plow and hitch adjustments....like draft control (the notched lever on left??? ) ?? ect...I put the tractors front and left wheel up on blocks and leveled up the plows as best as possible till the r hand fh arm screw was stopped....I have a op manual and pm manual for my 560 but may need one for the plow.. Thanks
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|