Farmall & IHC Tractors Discussion Board |
C casting and engine serial #
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by karl f on May 06, 2007 at 22:54:15 from (172.131.56.69):
lookin at our junked c today, has R and S castings on majority of tractor. that would place it in early production--serial tag is missing. engine was replaced at least once before. the engine serial number starts FCM. has a casting date of O on the block on the distributor side (did not look closely at any other engine casting # as that block is junk). what might this have been off of? i assume FCM would equal farmall c. noticed an interesting casting just below the platform date code on the edge of the platform near the clutch: "L No. 1" is this anything special or did this occur often? also there is an MF cast into the touch control lift body. massey have something to do with those hydraulics? been pretty bored lately had lots of free time today -karl f
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|