Farmall & IHC Tractors Discussion Board |
H 300 U hydraulic questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by bil b va on May 06, 2007 at 05:39:35 from (209.240.206.198):
i have only about 500 psi when trying to lift .i have IH-10 shop manual. in reading through testing and trouble shooting the shop manual says for testing disconnect all cylinders . are the lines to be capped ? i would think so but the book don't say . my tractor has a block bolted to the housing just in front of the brake pedals with 3 steel lines to the 2 forward valves ( 3 valve system ) . is this a check valve ? this is where i tapped into the system to get my pressure reading with a forward valve actuated . i have a parts manual and so far i haven't found this part . any checks i sould do before tearing into the safety valve and regulator . i bought this tractor last fall and am going over it before painting . all advice appreciated . bill
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|