Farmall & IHC Tractors Discussion Board |
Re: magneto for farmall m ?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rootsy on May 03, 2007 at 09:15:22 from (24.176.33.123):
In Reply to: magneto for farmall m ? posted by james in mo on May 02, 2007 at 16:07:33:
Get the charging system operating properly, or convert to 12 V (either in the generator or go to an alternator). You will regret it otherwise, after the novelty of the mag has worn off... especially if the tractor isn't dead instant to start or is cold blooded and you live in a climate where it can get cold... Speaking of dangerous hand cranks... my little 38 / 39 styled JD L took me for a ride around the crank handle when i was about 14... didn't break anything but my pride, just a few cuts and bruises after it bounced me off of the gravel in the driveway... It's a real bummer when they try to run backward on ya...
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|