Farmall & IHC Tractors Discussion Board |
Re: OT: Some questions about Trees
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on May 02, 2007 at 08:09:38 from (199.17.6.122):
In Reply to: OT: Some questions about Trees posted by JayWalt on May 02, 2007 at 07:34:28:
Even with good grafting techniques, the process will take 10 years to produce a substantial "center" trunk. I would run ready rod through the two trunks about 20 inches above the crotch, and call it good. Pull the two trunks together with a ratchet strap five feet above the crotch. Then use a long 1/2" auger bit to go through both trunks about 20" above the crotch. Using 9/16 ready rod, and two nuts jambed together, screw the rod into the 1/2" hole and you are done. If alignment is a problem, make a tab for each of two ready rod pieces and bolt them together in the crotch. I would ask a nursery for appropriate fungicide for the walnuts. JimN
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|