Farmall & IHC Tractors Discussion Board |
Re: FOR STAN IN (VA.) HELP ON O-RING SIZE FOR SLE
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on April 16, 2007 at 10:10:29 from (199.17.6.122):
In Reply to: FOR STAN IN (VA.) HELP ON O-RING SIZE FOR SLEEVE posted by COPPER KAT on April 15, 2007 at 17:55:41:
More than one o ring can be placed in the existing groove if the space is pretty much taken up from top to bottom, and the section of the rings used do not extend out more than 20% of the diameter of the section. Care must be taken on assembly to assure they are seated, and not crossed with each other. Another possible solution is to mill the outside of stock 3.25 sleeve O rings using a groved mandril and grinding gently to mill the outer surface so it has the same (or a little less) extension into the spigot hole. I would then use blue RTV on the flat of the ground Oring to assure a seal in the old groove bottom. All of these will require some practical engineering and measurement. Orings need to compress into their groove about 20% to seal corectly in the groove. One that is ground will have less resiliance. I hope this helps, JimN
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|