Farmall & IHC Tractors Discussion Board |
governor setting
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Pat-CT on April 10, 2007 at 18:57:27 from (68.14.157.191):
i dont know if i spelled governor right but anywho i was wondering when i took apart my h govoner this last weekend i saw a bolt that stoped the throttle from going up to high kind of like a speed limiter. well i was wondering if i could back this screw out to get a little more power going up hills in road gear? ok question numer 2 When going up a hill or starting off on a hill in road gear could i let the clutch out (the engine bogs but gets me rolling) then push in the clutch let the engine get up rpm then let the clutch go again without damageing the clutch i saw someone doing it on youtube with a c or super c ill post the video
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|