Farmall & IHC Tractors Discussion Board |
1066 Hyd Clutch-Hey Owen AaLand
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Michael Sheik on April 04, 2007 at 19:02:41 from (65.255.65.229):
I just took a look at the holes in the two pins and both were filled with dirt and rust. Dug them out with small screwdriver and it looks like a quarter inch hole on both and looks like both have threads. I think tomorrow on my day off I will construct a little slide hammer assy to try to pull the pins. If my hammer is a success, I will take a picture and post it. On the leak on the fitting on the MCV, it is the fitting above the one I was looking at and the one you pointed out. I am going to try to wrench it a little in the morning. If it doesn't move, it looks hard to pull. Oring here or what?
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|