Farmall & IHC Tractors Discussion Board |
Re: 656 diesel pump connection leak - novice
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fromjb2 on March 29, 2007 at 19:58:53 from (74.101.67.211):
In Reply to: 656 diesel pump connection leak - novice posted by Hay4horse on March 29, 2007 at 19:30:00:
Hi Hay4horse, I assume you are referring to one of the individual high pressure injector lines. If it is fully tightened then there is a possibility of a very small crack in the line. There are usually no O-rings. BE VERY CAREFULL THESE LINES ARE UNDER ABOUT 3000 PSI pressure when the engine is running. If it is a small crack you have two options, one get it brazed by an experienced welder or replace it with a new one. The replacement has to be identical, you just cannot make a replacement from a piece of steel tubing. When engine is stopped you can replace the leaky line with new one and not have to bleed fuel system. JimB
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|