Farmall & IHC Tractors Discussion Board |
Re: Farmall 300 spark plug wires
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on March 23, 2007 at 06:37:26 from (199.17.6.122):
In Reply to: Farmall 300 spark plug wires posted by Lupe Rodriguez on March 22, 2007 at 18:47:55:
if it is normal, it is: 2-1 4-3 looking from the rear of the tractor. #1 is front cylinder. The issue is that the engine will run correctly and be in time in a number of positions if assembled differently. so the real info (If the dist has not been pulled out) is to turn the engine with #1 spark plug out, and your thumb, or a round end fat stick in the sparkplug hole, until compression pressure blows air out. Then grank further very slowly to get the piston to the vry top. (the timing marks on the front pulley will then align) now you know for sure which is #1 on the Dist cap. JimN
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|