Farmall & IHC Tractors Discussion Board |
Re: I H 1486, 3 point not picking up
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Owen Aaland on March 22, 2007 at 12:44:52 from (65.165.246.14):
In Reply to: I H 1486, 3 point not picking up posted by Ron Bailey on March 21, 2007 at 17:53:31:
As a quick first check to see if the hitch works, move the remote control valve levers without a cylinder attached. If putting the system on high (relief) pressure allows the hitch to work, the unloader valve is stuck. There is a little pin that can come out of the linkage. I think it is on the draft control if I remember right. The cover you want to remove is the upper link bracket, Held on with six 5/8" bolts located right above the PTO. The linkage will be on the right side. Probably need someone to move the levers as you watch through the hole.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|