Farmall & IHC Tractors Discussion Board |
Re: Cracked Block Repair
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JayWalt on March 14, 2007 at 04:35:17 from (70.226.9.210):
In Reply to: Re: Cracked Block Repair posted by Tom Windsor on March 13, 2007 at 22:15:15:
tom, I have used some of these "new technology" rods. They are more costly then regular steel rods, but not bad. I bought a pack of I think it was 20 1.8" rods specially for cast iron for around $7. They work great, my bro did the welding on my cast ircon exhaust/intake on my 300u. Still holding up great. Ideally a noncracked block would be the solution. This crack looks like it could be structural. Does the superA have frame rails? If it doesnt and the crack is at a point near a mount, I wouldnt trust it. Seems welding cast is ok for nonstructural items. I wouldnt trust it structural unless it was done by a professional with credentials.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|