Farmall & IHC Tractors Discussion Board |
Re: Farmall H Countershaft/brake drum seal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SuperA-Tx on March 07, 2007 at 10:34:52 from (4.90.6.122):
In Reply to: Farmall H Countershaft/brake drum seal posted by Rob Flory on March 07, 2007 at 09:06:13:
What I have found is the old seals are over twice as thick and if you look inside the old seal there is actually two seals together seperated by a piece of rubber. I like to put two seals back in but I only do that if there isnt any groove cut into the shaft. If theres a groove then you can use one and avoid that groove usually. A piece of pvc pipe the same size as the shaft comes in handy sometimes. I put my seals on where they are "face to face" and the second one is hard to get on without putting it on the pvc pipe first and then sliding it onto the shaft.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|