Farmall & IHC Tractors Discussion Board |
Re: What gives one governor more RPM than another?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hayfarmer on March 06, 2007 at 07:22:16 from (66.243.245.229):
In Reply to: What gives one governor more RPM than another? posted by Lunatic Fringe on March 05, 2007 at 11:52:05:
Are you adjusting the linkage correctly? Is the shaft between carb and governor lined up and free. If anything inside the governor is hanging up, ie the bearing that slides, it could make it surge. I agree that the carb may be the problem. On my SMTA I installed a heavier spring and it will hold the higher RPM longer but eventually runs out of fuel so will drop back, grabs more fuel and picks up again. On it I turn screw out a couple extra turns when using it on heavy load and back it off when it doesn't have to work.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|