Farmall & IHC Tractors Discussion Board |
Re: getting a W-6 (248ci.) to idle down.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by farmallhal on March 04, 2007 at 14:18:21 from (64.85.221.207):
In Reply to: getting a W-6 (248ci.) to idle down. posted by Charles McNelly III on March 04, 2007 at 12:57:10:
Charles, I had the same exact problem on my M when I first got it. I just opened up the governor and adjusted the two adjustment screws, one is the idle stop screw (top one) and the speed adjusting screw (bottom one). I used the detailed directions in the service manual for my adjustments. Been running correctly ever since. There is another adjustment that can be done inside the slanted cover at the front of the carb throttle shaft which might be your problem. There are some other adjustments noted if for some reason you can't get it adjusted with those adjustments. If you don't have a manual maybe someone will jump in here with their solutions. Good luck, Hal.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|