Farmall & IHC Tractors Discussion Board |
Re: Farmall A low oil pressure when hot
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Owen Aaland on February 25, 2007 at 22:35:00 from (65.165.246.11):
In Reply to: Re: Farmall A low oil pressure when hot posted by jakee on February 25, 2007 at 21:23:08:
Pay attention to where the gasket is blown out. this is the area where the plate will be warped. After sanding it flat, reinforce it with a small steel bar. I use a piece 1/4" thick and 1/2" wide. You will need to notch it a bit to clear the web on the cover. Drill a hole for the bolt on each end and use longer bolts. When you are ready for the final installation, put a slight bend in the middle of the bar so that the center presses on the cover befor the ends are drawn down. I have done this to quite a few pumps and have never had another gasket failure with any of them.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|