Farmall & IHC Tractors Discussion Board |
584 4 wheel drive
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don Stear on February 22, 2007 at 08:12:07 from (69.72.18.110):
Have a chance to get an Int. 584 with 4 wheel drive and loader. I have a 584 2 wheel drive and it is a great tractor. Have never had a 4 wheel drive other than a small Kubota. I was told that this tractor with 4 wheel drive has an extremely wide turning circle and that this is a problem. Is it that bad? Is it a lot wider than other 4 wheel drives? This tractor came to the states from Canada and the loader is not a 2250. The owner says it is better than a 2250, that it is more heavy duty. It is a quick detatch loader and the bucket is also quick detatch. I don't know the make. Is this tractor so rare that parts will be hard to find? I have not seen a 584 with 4 wheel drive before. Any specific problems to look for on this tractor? Would $10,500 US be a reasonable price for this outfit in average or above average condition? Thanks in advance for any help/info.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|