Farmall & IHC Tractors Discussion Board |
Re: H radiator removal/rod bearing size
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by walt f on November 18, 2001 at 20:53:36 from (24.159.77.113):
In Reply to: H radiator removal/rod bearing size posted by Larry on November 18, 2001 at 20:10:28:
the rods on my f-20 have punch marks on the side of each rod where the rod bolt goes thru, one punch mark for cylinder one, thru to four punch marks for cylinder four, the rod caps also have the same punch marks. all f-20s that i've taken down, have the same punch marks, and they all face the camshaft side of the crankcase. the punch marks were made with a center punch. i've never taken a h or m down so i don't know if they use shims, but be careful to put each rod and cap back in the same place, turned the same way. do one rod at a time and lay each rod down on a clean (clutter free) surface, that will not be disturbed while you are working on your engine. mark each piston face with a center punch if it's an aluminum piston or a scratch awl (scratch the number on the piston face), if it's cast iron. the face is the part of the piston that faces the fire (top of the piston).
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|