Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall M-four bottom?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ralph on October 31, 2001 at 06:34:59 from (65.45.140.127):
In Reply to: Re: Farmall M-four bottom? posted by Denny Frisk on October 31, 2001 at 05:42:02:
Hi Denny: You make a good point about overstressing the drivetrain but some of these M's have been working 50-60 years without major rearend problems. I'll guess it's abusive drivers quite often. I've seen some just beat the He** out of whatever they'er driving. Anyway, another point is I don't think running 50HP through the drivetrain in 3ed or 4th would make so much easier than using that same 50HP in 2ed?? 50HP either way. If ya hit a stone the shock will still be to a drivetrain that's under a 50HP load. Only sure way would be to reduce power back to closer to stock 40HP?? Not downgrading anyone, just wondering about stress using 50HP nomatter the gear vs reducing to 40HP. Abusive driving is a second issue. Take care. have fun. ralph
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|