Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Need Touch Control Expert
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Clyde on October 21, 2001 at 14:45:42 from (63.146.82.113):
In Reply to: Re: Re: Re: Need Touch Control Expert posted by J. D. Humm on October 21, 2001 at 13:55:41:
They are not seized. I can push them in and they spring back about 1/4" short of even with the head. I do have the parts book and that makes sense as there are springs behind them. I don't think anything is holding them in except oil suction and their o-rings. They are not steel and a magnet won't stick to them. I also tried my shop vac in desperation. As far as the access hole it is maybe 4" down to the backside of these actuators and it is only a 3/8" hole. I tried prying again pretty hard with a small scredriver but am afarid I will scratch something. I'm sure there must be a trick of some sort. Maybe your's were sticking out beyond the head a little when you took it off.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|