Farmall & IHC Tractors Discussion Board |
Re: Auxillary Hydraulic Valve on M with live hyd
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by charlie U on September 22, 2001 at 19:20:44 from (216.188.194.228):
In Reply to: Auxillary Hydraulic Valve on M with live hyd posted by Dick Davis on September 22, 2001 at 16:28:48:
There is an O-ring that seals the spool that runs up and down in that valve. I don't remimber for sure if there is a grove cut in the spool or if there is a grove cut in the housing for the o-ring to fit into and then it just rides on a smooth part on the spool. It's been a little while since I have had one of these valves apart but it's quite simple. The cross shaft is not designed to stop any oil. I have one that is so loose it's a miracle that it still works. Some day I'm just going to have to build up the shaft and maybe the housing too because she is so loose. Good luck with the job of replacing the o-ring. There is only one o-ring in that whole valve and that is the one that is leaking for you.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|