Farmall & IHC Tractors Discussion Board |
Re: More With H Steering
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on July 18, 2001 at 10:32:36 from (192.232.119.194):
In Reply to: More With H Steering posted by 1PWRFULH on July 18, 2001 at 09:47:44:
Sounds like the bolser pivot shaft thrust bearing has failed. When the front end is jacked up can you see signs of wear on the underside of the upper bolster casting where the top of the pivot shaft flange (where the lower bolster bolts on) has been rubbing? If so that's a sure sign the thrust bearing is gone. If no wear is noted, then perhaps the nut that holds the sector gear onto the top of the pivot shaft is loose or missing - which can make your steering REALLY sloppy! First thing to to would be to remove the grille and the steering gearbox cover for a peek inside, then jack the front end. That should show you the source of the vertical play. Good luck!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|