Farmall & IHC Tractors Discussion Board |
special use of Farmall M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John on February 23, 2001 at 07:44:09 from (207.226.109.67):
Considering buying M or Super M. Want to run a concrete mixer off the PTO This is a 3 point set up with the top link being Hydraulic. It works like this... Tractor running and in neutral, PTO is turning the mixer. After mixer is in the proper position the lower lift arms are disabled with wood blocks. The hydraulic top link is used to raise and lower the angle of the mixer to load and dump the concrete. I will need to be on the ground standing next to the mixer.Is there any problem in doing this with this tractor? I know of the safety issues... I am already using this mixer on another tractor that has add on motor driven hydraulics so I know how to set it up... Feed back is appreciated... John
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|