Posted by Lloyd in South Carolina on May 03, 2011 at 05:52:36 from (162.111.235.36):
Last summer I wired the small Barn/Shed at our new place. Had underground service put it, wired a panel with just basic service, 6 outlets and 5 porcilen light fixtures..... 2 circuits. Not the most complex wiring I've ever done for sure. It all passed inspection and I thought I was good to go.
The driven me nuts part..... Have a light circuit, 5 regular lights (100 watt bulbs) wired in series on 1 light switch. I'm on my 6th light switch,,, yep bought the good ones, and the cheap ones and they last about 6-10 cycles (turning the lights on and off) and the switch is shot. Obviously something wrong with my circuit!!!
#1) I've had all the fixtures apart 3 times, nothing crossed, all is wired correctly.
#2) I've left the lights on all day while I'm there on site, nothing gets hot, it never fails.
#3) Last 3 months I've used the breaker to turn the lights on and off, same switch has lasted many cycles.... of course the switch is staying on,,, not cycling.
All I can think of is I have a bad wire somewhere. At this point thinking I need to rewire the entire cicuit with new wire.
Anybody have any thoughts on how I might eliminate it down to one wire run? They are ran in series, switch to closes light, from that light to the next etc etc..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.