Your pix says the stick had a poor grain.Were the screws missing when it broke.One sure way to break a stick is to strike a rock with the end of the knife.Run the knife shoes as high as possible.The slip clutch will take care of grass binding.The knife has to be kept SHARP.Take a close look at the grain of the wood on new sticks.New pitman Sticks are 25 bucks here.Tsc only stocks blanks here at 12 bucks.I will make my own at these prices.Ash or white oak is the best wood.Hickory would be good but it dosent grow here.Theres a lot of labor in a pitman stick but prices are just too high.Your broken stick would have made a poor ax handle with it diagonal grain.Take measurments off your broken stick to make a new one.Making the hole for the latch spring will be the hard part.Years ago I needed new wood for the plunger on my baler.Dealer wanted 49 bucks for 2 hard maple sticks with a few holes in them.I said no thank you.I had a few hard maple planks up in the hay loft.I had the 2 pieces made in a half hour.At that time I could have bought a cord of ash fire wood for 49 bucks.Ash dosent weather well so it would be best to take the pitman arm off and hang it up under cover after the mowing is done.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
