Posted by Lloyd in South Carolina on April 12, 2011 at 10:13:19 from (162.111.235.36):
Have a tech question on cement. Here's the input data.
#1 Poured cement for the gate posts Sunday, 24" by 6'6" holes. I believe I used just over 2 yards to fill the 2 holes.
#2 The holes were wet, in fact 5' of water in them just before I poured. Ground water, not rain runoff. Pumped the water out, started pouring the cement. Bottom 3' of each hole, made a dry mix,,, just damp,,, cause there was water coming back in the holes. After I poured each wheel barrow in, mixed it as best i could with a long handled shovel.
#3 Used portand cement type II. Mixed by hand in a mixer, tried to stay a little rich on the mix.
#4 See the pictures, the gates and a pic from the block manurfacter gallery. There will be 68 of those block/stones dry stacked around each I beam, they are 41 lbs each, so 2,788 lbs sitting on or around each post.
THE QUESTION......... How long do I wait for the concrete to cure before I dare add these to complete the project?
Thanks for your help with this!! You'all are always in the know!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.