As a forester I will say find a good reputable forester in your area. Have him walk the stand with you to find out what your goals are for the area. Then have him write a long term management plan for the area. Then if a timber sale is in the works have him mark the trees and put the sale out to bid.
Having nothing smaller than 20" cut is bad practice. Trees over 20" can put on good growth and retain a lot of value. Where as a tree smaller than 20" that is junk now will still be junk in the future... All things a good forester should discuss with you. Also leaving the tops on the ground provides a "slash mat" for the equipment to drive on, thus reducing damage to the soil. The tops also decompose and help build up the soil.
In a hardwood stand generally the best management practice is to thin the stand to a certain density and perform that thinning across ALL of the diameter range.
Personally I mark stands cutting the worst and junk first to get to my target density. Then if more is needed start working on marking some of the better trees (or anything that you feel isn't going to survive until the next harvest). Leaving the best trees for good genetic seed source and to put on growth and value during the next harvest cycle.
This post was edited by chevytaHOE5674 at 19:16:26 04/01/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
