Posted by RodInNS on March 30, 2011 at 17:34:10 from (24.224.246.101):
In Reply to: How would you do it ? posted by Billy NY on March 29, 2011 at 16:13:47:
Actually... some lock collars do use two set screws. It's hard to tell from the angle of the pictures but that does look to me like a collar lock bearing. If it is you'll find a punch hole somewhere on the collar. Back the screws out. Lock collars are supposed to be locked in the direction of rotation... so you figure out which way the shaft turns, then punch the collar back the other way... That said... might still not come loose. You can either burn it off or get a separator behind it and try pulling it off that way (if you want to save the bearing). If it was me... I'd burn it off in less time than it took to read this. Old bearing = DRY bearing... means you'll be doing this sooner or later. Might as well be now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.