Posted by dave2 on March 30, 2011 at 12:05:29 from (79.240.154.246):
ripped all the dividers and wall boards out of the stalls that were sawmill slabs and getting pretty shabby. replaced the dividers by lagging U channel to each wall and dropping in planks that are getting a good soaking with stain. Solid walls and inside of doors are getting 3/4 inch plywood cause I have plenty on hand. The back wall is cinderblocks that I need to patch up from years of kicking holes in them.
Now the questions.....
I have a bunch of 2x2ft and 3/8 inch thick rubber mats that I saved from the dumpster (floor covering in the weightroom of the local gym).
I've been moving them back and forth for the last few years and had a shazam moment today. There is just enough to cover the block walls in the stalls. What would be a good glue to stick them in place and not have to worry about them again?
As for paint, need to paint the cement and plywood walls. I can pick out paint OK but was thinking about whitewashing so the material can still breathe. Anyone still do that, or is there a better idea out there? Just want to brighten things up a little make it easier to clean.
Thanks for any tips concerning the topic. I can handle my grammar and spelling.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
