Posted by Beatles65 on March 29, 2011 at 20:51:23 from (216.229.21.24):
My great uncle has an old Ford 9N and he wants me to go and help him get it running. It was running last fall, and when it was running he had to have the choke pulled out all the way to keep her going. Ever since last fall he has not run the tractor and now it will not start. He lives about an hour away from me and I think this weekend sometime we are going to go down and see if we can fix the tractor. I figure that the reason for it not starting is the carb it gummed up. Plan on taking new plugs, wires, tune up kit, etc. and carb chemical dip to get the tractor running again. But, we might have to go further and rebuild the carb and clean the passages.
I have never messed with a Ford carburetor before, only John Deere.
What are the correct drill bits for clearing the carburetor passages?
What Plugs does it take?
Any other advice would be very appreciated! Thanks for the help! From Denton, Nebraska. Andrew Kean
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.