Trent. Couple of questions. Was the tiller setting outside with out covering the engine? If the engine was covered still some rust may have accumulated on the flywheel (where the magnet strip is imbeded)if that is so, then lightly sand paper the strip and remove the coil. There will be rust/dirt on both prongs. Clean it the same way. Now when you replace the coil. use A PLAIN PLAYING CARD (ace of spades or any others) as that will insure you the correct spacing between the coil points and the magnet strip. Tighten the coil down with the card still inserted between the coil and flywheel. Spin the flywheel by hand, remove the card. Should be spark (if the coil is good. Put a small dab of fuel in the plug hole and give it a pull, Should start. Hope this helps. Ps Look for mice nests . Regards LOU.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.