Posted by c-man on March 21, 2011 at 16:52:16 from (69.77.197.213):
In Reply to: what's a tedder? posted by c-man on March 21, 2011 at 03:32:58:
Thanks for the replies guys. I guess we are "lucky" that we can usually get the hay dry just with a wheel rake and usually get it baled the day after cutting it. If we flat mowed it in the morning, we would probably be able to bale it the same day most of the time, using just a wheel rake and a little sun and breeze. We have used an inverter to get some proso millet dried that had been swathed and then rained on. It was basically a pickup with a conveyor that moved the windrow off the muddy ground. And the windrow was mostly tipped over so the wet bottom became the top. Worked quite well. Didn't shell as much grain as a wheel rake would have.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.