Posted by PJH on March 19, 2011 at 22:46:40 from (50.40.164.229):
In Reply to: OT Hand pumped water posted by Heyseed on March 19, 2011 at 18:12:03:
When I was a kid - we had a neighbor who had a drilled deep well with no pump in it. He had a simple little roof over the well, with a well pulley, and the bucket looked like a piece of round galvenized downspout about four feet long. It had a round ball in the bottom of it. He'd drop it in the well and the ball would rise up letting the "downspout" fill. As he raised it, the ball would seal the bottom and hold the water. He'd drop the bottom of the "downspout" in a five gallon bucket - that would dislodge the ball and allow the water to flow into the bucket. I've hoisted a lot of water out of his well in my younger days.
It would NOT work if a pump/lines were already installed in the well.
I'd like to find one of those "downspouts". That's the only live one I've ever seen.
Lehman's, the Amish store in Ohio, has them in their catalog for upwards of $100.
If our grid ever goes down, from trying to charge all these electric cars, I'll get thirsty before I get one made.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.