Not mistaken,just put a picture of what I was talking about being toe close mesh,a gear set is a gear set, regardless of what oil they run in, you have to move the pinion by shims or the ring gear by shims,exceptions are newer designs. older ones are either shimmed,or spaced by shims to get the desired effect of gear mesh.Without bad wear characteristics, howling or annoying whine,although with some older models some whine is unpreventable.The tooth contact should be shaped,for lack of a better description, like a cigar or submarine,with the most contact at the center of the tooth,not at either edge or close to the top only.Not trying to ruffle feathers,but I can remember rear differentials and transmissions ran 40% mineral oil for lubrication,makes no difference what the lubrication is,it is all set the same way,just different angles of the tooth. Regards,Victor & LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.