Posted by John T on March 10, 2011 at 06:47:51 from (66.87.7.160):
In Reply to: 12V wiring question posted by Brad Gyde on March 10, 2011 at 06:07:07:
If youre converting to 12 volts Id use Negative Ground,,,,,,
I would use a 3 wire (BAT ARM FLD) full fledged 12 volt Voltage Regulator versus messing with a Cutout Relay and any LHBD ligth switch charge regulation. Make sure the VR is suitable for NEG ground,,,,,,
BAT on VR to load (NOT battery/starter) side of ammeter......ARM/GEN on VR to ARM post on Genny,,,,,FLD on VR to gennys FLD post,,,,,loads like lights/ignition switch get hot battery voltage supply from LOAD side of ammeter, same terminal that wires to BAT on VR. Other Supply side of ammeter gets hot battery voltage often where big battery cable wirres to starter switch.
If it was Pos ground before, ammeter leads need reversed or it will read bass ackwards.
Polarize the genny BEFORE start up
LOOK AT BOB M'S WIRING DIAGRAMS
If this isnt the answer youre looking for I dont know what to tell you
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.