Posted by Gchase24 on March 09, 2011 at 20:01:02 from (70.252.190.78):
In Reply to: Is this safe? posted by GeneMO on March 09, 2011 at 15:44:37:
No it,s not safe! I had a safety cage from the plant.It was made for a fork truck so I put my forks on my loader ,put safety chains so it would not slip off the forks.Thought everything was safe. Had my nieghbor lift me up ,started trimming with my chain saw.Everything was going fine and was about to finish when I cut a 2" limb about ten feet long.When I cut it it fell towards the tractor lodging between the joystick and the fender of the tractor. I was ejected from about ten feet on to my head. Split my scull, major concussion three days in hospital and saveral weeks recovering.Do,nt do it
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.