Posted by VicS on March 09, 2011 at 17:54:03 from (98.134.203.245):
In Reply to: Tips for growing corn posted by Reid1650 on March 09, 2011 at 17:19:45:
Spray it with Roundup or Generic Roundup 2qt rate tomorrow! Would have been better last fall. Seriously spray it as soon as possible. Spred your fertilizer as soon as you can 250 lb 18-46-0 and 250 lb of 0-0-60 If you don't get to plant till May, Spray again with RR plus 24D Buy good seed! all the packages! Don't buy a Race Horse no. Ask a successful farmer dealer what seed number they would use. Plant at least 26000 seeds per acre. Always Knife in your Nitrogen Anhydrous Deep 120 lb actual, when the corn is 6 in to 1 ft high. Spray it again with RR and a residual herbicide.If you don't have enough Horse Power, just do every other middle, or 60 in centers. so 3 knives for 6 rows.You can find those old tool bars for $500 or rent one from your fert dealer. Or hire it done. Don't let anyone talk you out of knifing in your Nitrogen.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.