Posted by Ultradog MN on March 09, 2011 at 07:27:22 from (70.58.237.63):
In Reply to: Well THAT was stupid posted by Ultradog MN on March 09, 2011 at 05:23:04:
Well, you guys got me worried about it so I called the clinic. They didn't get half as excieted as many of you here did. They put me in touch with the eye clinic and I spoke to the nurse there. She asked me a whole lot of questions about what happened and my symptoms then said I was probably ok at this point. She said I woulda,shoulda,coulda come in yesterday but since I didn't and my eye isn't too bad this AM I was probably ok. She said I could come in if I wished... I asked her what she would do and she said at this point just keep an eye on it (so to speak) and call back if it doesn't improve rather quickly - like most of the symptoms gone by this afternoon. Maybe in my original post I shouldn't have used the word deflicted - too strong a term. Mostly it's just a little sore and pink a little now. I can see fine. I think I'll be ok. Thanks to all for your concern. When I posted I expected to catch a lot of ribbing for being so dumb and not the kindness. This is a great board. You all be careful around those thinners and cleaners though. This ordeal wasn't much fun. Jerry
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.