The rods don't pick up hydrogen embrittlement from sitting. The welds get hydrogen embrittlement in the molten state if there is too much moisture in the coating. If the rods are kept in a sealed container at room temperature, they will be fine 95% of the time. You could always warm the rods a little before using them. Someone suggested putting them in a portable BBQ to warm them up and some guys just stick the rod to the work for a few seconds to dry any moisture. If the rods have been soaked, then they need to baked at high temperature for several hours. Most people would throw out rods that got wet though. If the projects you're doing can be done successfully with 7014 and especially 6013, they are not in the category of critical welds. Wet 7018 will weld very poorly and usually have porosity. Lanse's 7018 looks just fine except for the stops and starts and that just takes a little more practice to perfect.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
