Posted by IA Leo on March 05, 2011 at 12:12:26 from (67.224.25.173):
In the early 90's my coworker and I in the co. Taurus coming back to Cedar Falls, IA from a flour mill in Ontario Province, was waiting for a light on the divided higway I20 near the Kennedy Mall in Dubuque, IA. There was there a series of stop lights, each with left and right turn lanes and the through lanes generous in width. A woman in a minivan eases up between us and the guy on right, kocking his driver's mirror out of adjustment,then proceeded to run the red light and then as we followed her on the green, she did that again at the next light, this time tearing her mirror off and, I think the mirrors of both the vehicles she was squeezing between. She made it through that red light only to tee-bone an oncoming left-turner at the next red light. We did not stop as there plenty of people running around the wreck that were witnesses. I would like to have heard why she did that, I cannot imagine doing something like that unless on drugs, prescribed or otherwise.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.