Posted by Jon Hagen on March 02, 2011 at 14:12:56 from (69.26.23.96):
In Reply to: Re: SIO Alt. posted by sam in mo on March 02, 2011 at 04:48:45:
That "Cutout" connected to the F terminal may be an early Chrysler mechanical alternator regulator(60-67) They work pretty well on a Delco 10DN like yours. It should not charge hard at all times unless the battery is low/ bad / shorted, or the Chrysler regulator is defective,not connected (mounting bracket) to a good ground or the switched 12V power to it has some resistance and voltage drop. Check voltage at the battery posts with the alt charging, it should not / must not be over 14.9 volts.
The chrysler mechanical voltage regulator has only two terminals, the one with a screw goes to the alternator F terminal. The flat blade quick connector terminal goes to switched 12V power from the ignition switch. Make sure this regulator connection is made before, not after any ignition ballast resistor. If this connection is made on the downstream(coil) side of a ballast resistor, it will send a false low voltage signal to the regulator and cause the alternator to charge flat out all the time. (make sure there is atleast 12V at the flat blade terminal of the regulator with the engine running.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.