Posted by JDseller on February 17, 2011 at 07:33:39 from (208.126.196.144):
In Reply to: pipe posted by Scott Blanchard on February 17, 2011 at 04:07:03:
Make sure and put a 90 degree elbow in it so it points right back at your head!!!! That way YOU get the full benefit of the crappy sound. Those smaller displacement engines don"t have a good rumble it is more a high pitch screech. You will not gain any horse power either. You might gain if it was a diesel turbo engine. Even then it is not much.
At My local show we put in a rule this year about no tractors over 100 decibels allowed to pull. Had too many guys with those GM diesel come in with straight pipes making too much noise. We got complaints last year from the neighbors. The owner of the grounds told us if we did not quite it down he was not going to rent to us anymore. I don"t blame him we have the show in a nice valley and those loud GMs echoed against the hills and you could not hear anything. My youngest grand kids only stayed a few hours complaining about their ears hurting.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
