Posted by Dan in North Houston on February 13, 2011 at 16:25:38 from (76.31.253.54):
In Reply to: 4020 3 pt hitch posted by Mark Gundrum on February 13, 2011 at 02:53:36:
After I finally got my lift arms free (took a 36" pipe wrench), I found problems with the threads on the male end of one side. There is about a 2" section where the treads are worn / stripped / corroded down to where they jump. Quick solution is to not screw it down to where that portion would be near the threads in the female end. Long term solution was to watch ebay for several months until I found a replacement. The replacement was frozen up too, but the 36" pipe wrench solved that problem again.
I don"t know what caused the problem, as one side of mine were perfect - assuming it was the same age as the bad side.
You suspect that the threads are bad on the female end. Is yours froze up completely?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.