Posted by ted regentin on February 12, 2011 at 13:24:21 from (216.110.201.109):
In Reply to: Re: Oxygen Sensor posted by Allan In NE on February 12, 2011 at 06:06:02:
"I'd just about bet that 90% of all O2 sensor replacements are done needlessly."
Just out of curiosity, do you have anything to back up that statement? I do driveability/electrical diagnostics, and I have replaced plenty of oxygen sensors. A good percentage of them are four wire heated sensors that the heater element is open. This problem can be very easily verified using an ohm meter. For the sensors that trouble codes indicate slow reaction or out of range, there are scan tool data streams that show long term adaptives and short term adaptives. Also, some manufacturers use operating cell stratagies that can help verify the problem. I normally can be sure most of the time before I replace an oxygen sensor. After I replace a sensor, I do enough test driving for the ECM to run its monitors that can verify systems operation. There is one specific problem that I will "throw" an oxygen sensor at. Some cars will set catalytic converter efficiency codes. There are times that I cannot be sure if the sensors are causing the problem, or if the cat is bad, so on occasion I will recommend trying new oxygen sensors first, then test driving and recheck the monitors. The reason that I do it this way, is because catalytic converters on some models are rather expensive. By the way, some newer models use something called an "air fuel ratio sensor" instead of the traditional oxygen sensor. I hope that all this isn't too technical for you, Allan, but the point of this post is that there is a lot to proper oxygen sensor diagnostics, and it takes a lot of skill, experience and training to do it properly. My shop probably has over $20,000 just in scan tools and I need a couple more to be efficient. Hope this helps,
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.