No, I don"t have an easier method of tracing, but would recommend maybe replacing the line if it is recurring. I"ve heard you can use an am radio but can"t remember how.
But I go through that break tracing about every spring. A few random comments that may or may not help you as you go: 1. After a while, the line does seem to give out underground. At that point, I"ve come to learn you start chasing your tail. You"ll find the break, then a month later your after another one. Not sure if it"s too many freeze thaw cycles or what. Now I just dig a new trench and replace it. 2. I use the backwoods install method. A 1" rod or concrete d-stake through the front snow plow on the tractor (plow removed) - has down pressure. Can run several hundred feet of trench quickly. Turn the two young boys loose burying the wire in it and closing it with their boots. Could probably do the stake through a 3pt drawbar with some weight too. 3. Part of mine is in a woods. No trench there. Just let it lay and it eventually buries itself. That"s also the place where rabbits, deer, and other varmints will chew through it. 4. Have had the best luck with non-stranded wire, one size bigger than they supply with the kit. 5. I usually splice the wire with wire nuts and silicone caulk.
Had lightning strike a tree in the woods about 10 years ago. The wire was a few feet from the trunk and as the wire runs, about 600 ft from the garage. It followed that little 16ga wire all the way in and blew the transmitter across the garage. Called petsafe, told them what happened. Sent them the transmitter in a bag, they sent a new one - no cost. Can"t remember if it was under warranty or what the deal was, but was very happy with the service.
I"m sure someone who installs the stuff will probably frown upon what I"ve listed above, but they seem to work for me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
