Posted by Danny Prosser on February 07, 2011 at 10:20:26 from (170.141.177.87):
I wanted to get ya'lls thoughts on this. I built a 24x36' shop concrete floor w/plastic under it. Light poles and 2x material construction with metal roof and walls.I want to finish the inside and this is how I was going to do it. Because its metal I have a codensation issue so I was going to staple plastic sheathing inside against the metal for a vapor barrier. Then insulate and put up 1/4"x4'x8' osb for ceiling and walls.I was thinking about running the electrical in conduit on the outside of the walls and ceiling for easy access if I needed to change anything.I built this by myself with 2 of my tractors pulleys and ropes.It also has a 24'x 32' lean to on one side.I built a pole barn 36'x 40'about 20'at the top with the tractors to.They make good helpers don't they. Thanks for you time and thoughts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.