The injection pump would be the last things I'd suspect with starting problems on a 2940 - as you described them.
White-bottle Power Service won't do much when you dump it into fuel that's already gelled. The red-bottle will - but only if you remove the fuel filter and dump some directly into the filter.
2940 uses the square fuel filter that easily gets plugged with ice chips at the bottom. That's a different problem then gelled fuel.
When you crack an injection line -even when the pump is working correctly, you will only see a few drops of fuel.
Also, injectors do not get "cavitated" if the engine is running - as long as fuel is flowing. If they DID have air, they will bleed themselves out.
I'm not saying CAV pumps never have problems. But, from you describe - I doubt it.
Also note that when the 2940 was brand new - it had many cold starting problems. It was probably the most problematic cold-starting new-generation diesel that Deere ever sold - dating back to 1960, anyway. We sold them new, and had to make many modifications on them. In fact, the 2940 problems led to Deere coming out with new style pistons.
I'm going by these comments you made earlier . . .
"the fuel filter was gelled even though I put new diesel in in Nov and put half a white bottle of power service in at that time. Ran the tractor several times since then with no problems. Thought maybe I had cavitated the injectors so I loosened the two nuts on one injector."
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
