Posted by Johnny from MI on February 03, 2011 at 13:47:33 from (74.115.62.95):
In Reply to: Snowblower option posted by Rick Kr on February 03, 2011 at 13:29:37:
A snowblower mounted on the loader is a pain in the butt. I used a neighbors that was on a four wheel dive tractor. In deep snow you could not turn because the blower was pushed sideways into to snow bank. He put a lot of work in mounting it there. Used a drop box off the rear pto with a long power take off shaft to front of tractor, then a sliding pto shaft to blower. You couldn't raise it up too far or the shaft would pull apart.I have spent many hours running a 8 foot blower on the rear of a 120 HP tractor. I'll take a rear mounted any day over a front mounted blower. I have operated tractors and heavy equipment all of my life, and it seems like most machines I have operated you spend a lot of time looking behind you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.